Equipment; Fuel - Echo PE-2000 1 Operator's Manual

EQUIPMENT

EQUIPMENT EQUIPMENT EQUIPMENT EQUIPMENT
Before operation a complete check of the unit must be performed;
•
Check unit for loose/missing nuts, bolts and screws. Tighten and/or
replace as needed.
•
Inspect fuel lines, tank and area around carburetor for fuel leaks. DO
NOT operate unit if leaks are found.
•
Inspect shield for damage and is securely in place. Replace if shield
is damaged or missing.
•
Check that the cutting attachment is firmly attached and in safe
operating condition.
•
Check that front handle is adjusted for safe, comfortable operation.
See Assembly for proper adjustment.
Spark Arrestor Muffler
The spark arrestor muffler controls the exhaust noise and prevents hot,
glowing particles of carbon from leaving the muffler. Make sure the
spark arrestor screen is in good repair and properly seated in the
muffler. (Refer to Exhaust System Maintenance pg. 23.)
Parts
• Do not use edger if any part is missing or damaged.
• Have repairs done only by an authorized ECHO Service dealer.
• Do not use any attachment, accessory or replacement part unless it
is recommended in this Operator's Manual.
WARNING
• Use only ECHO approved attachments. Serious injury may result
from the use of a non approved attachment combination. Read
and comply with all safety instructions listed in this manual and
safety manual.
• ECHO, INC. will not be responsible for the failure of cutting
devices, attachments or accessories which have not been tested
and approved by ECHO.

FUEL

WARNING
Fuel is VERY flammable. Use extreme care when mixing, storing
or handling or serious personal injury may result.
•
Use an approved fuel container.
•
DO NOT smoke near fuel.
•
DO NOT allow flames or sparks near fuel.
•
Fuel tanks/cans may be under pressure. Always loosen fuel
caps slowly allowing pressure to equalize.
•
NEVER refuel a unit when the engine is HOT!
•
NEVER refuel a unit with the engine running.
•
DO NOT fill fuel tanks indoors. ALWAYS fill fuel tanks
outdoors over bare ground.
•
Securely tighten fuel cap after refueling.
•
Inspect for fuel leakage. If fuel leakage is found, do not start or
operate unit until leakage is repaired.
DANGER
DANGER
P E
OWER DGER
O ' M
PERATOR S ANUAL
ATTACHMENTS
AND
ACCESSORIES
5