Displaying A Video Image - Proxima DP8200x User Manual

Displaying a video image

Remove the lens cap.
Press the power switch to position "1" on the back of the projector, then
press the Power button on the top of the projector.
The LED flashes green and the fans start to run. When the lamp comes on,
the startup screen is displayed and the LED is steady green. It can take a
minute for the image to achieve full brightness.
? No startup screen? Get help on page 16.
Plug in and turn on the video device.
The video device's image should appear on the projection screen. If it
doesn't, press the Video button on the keypad.
Adjust the height of the projector by pressing the release button to extend
the elevator foot. Rotate the leveling foot, if necessary.
Position the projector the desired distance from the screen at a 90 degree
angle to the screen. See page 42 for a table listing screen sizes and distances
to the screen.
remove lens cap
press Power switch press Power button
I
O
turn on video device
adjust height
elevator
foot
adjust distance
14
2
1
rotate
leveling
foot