Location Control Icons; Color For Resin/Paint; Fire Enclosure Request; Resins - Philips 273E3LHSB/00 Service Manual

5.5 Location of Control icons -
Per Philips Graphic sheet

5.6 Color for resin/paint -

Per Philips make-up sheet

5.7 Fire Enclosure Request

Shielding cover should fulfill international standard.

5.8 Resins

RoHS required
WEEE required.
Resin type/selection refers to Project Book Section 7.2 Plastic material.

5.9 If paint is used

RoHS required
WEEE require
If new painting type needs to implement, refer to UN-D 1235.

5.10 Plastic mold tooling

Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld lines,
gate marks, ejector marks, etc.). Refer to "TYV61-90007".
Painting to cover up cosmetic defects due to molding is strongly discouraged.
China RoHS mark requested.

5.11 Plastics flammability

All Plastics to be Flame Retardant UL 94-HB or better.
Base / Rear to be Flame Retardant UL 94-HB.
All major plastic parts (bezel, back cover) need to be molded from same resin.
Plastic resin type selection should be referred to "plastic-Philips Pool monitor".
5.12 Texture/Glossing of housing
The texture area and texture no should follow Philips make-up sheet.
The exterior surfaces shall have a uniform texture.
Philips must approve the mold texturing.
Detail document for texture refer to "UN-D249", "UN-D 600".
>= 80 gloss units

5.13 Gap, step of F/C and R/C

Gap between bezel and panel
Gap between F/C and R/C
Step of F/C and R/C -0.3mm Left
1.2 (Typ.) mm
0.4mm
right ,top, Bottom , corner : 0.5mm
Meridian 3
75