Valet Switch; Keyless Entry In Valet Mode; Ultrasonic Sensors; Instant Remote Control Code Deletion - Avital MAXX2 Owner's Manual

Valet Switch

The Valet switch is a small push-button switch that allows you to
control all of the system's programmable features and enter your
override PIN code. (See User-Programmable Features section of this
guide.) This switch can only be controlled in conjunction with
your ignition key.
NOTE: Make sure the dealer has shown you where the Valet switch is
located. You will need to disarm the system with the Valet switch in the
event of a lost or stolen remote control.

Keyless Entry in Valet Mode

While the system is in the Valet mode, you can still use your
remote control to lock and unlock the doors as well as activate any
optional accessories, such as boot release or remote engine starter.

Ultrasonic Sensors

Your Maxx 2 security system incorporates two Ultrasonic sensors,
which are most commonly mounted at the top of the A-pillars fac-
ing the rear of the vehicle. These sensors detect movement inside
the vehicle by sensing air disturbance. They should trigger the
alarm if a thief gained access to the interior of your vehicle.

Instant Remote Control Code Deletion

In the event of a lost or stolen remote control, all remote controls
can be erased from the systems memory preventing unauthorised
system operation. (See the Programming Table for Remote Controls
section of this guide.)
®2002 Directed Electronics, Inc.
9