ProForm PFTL58580 User Manual page 8

DIAGRAM OF THE CONSOLE
Incline Control
Pulse Sensor
CAUTION:
console, read the following precautions.
¥ Do not stand on the walking belt when turning
on the power.
¥ Always wear the clip (see the drawing above)
while using the treadmill. When the key is
removed from the console, the walking belt
will stop.
STEP - BY - STEP CONSOLE OPERATION
If there is a thin sheet of clear plastic on the face of the
console, remove it. Next, make sure that the power
cord is properly plugged in (see HOW TO PLUG IN
THE POWER CORD on page 7).
Stand on the foot rails of the treadmill. Find the clip
attached to the key (see the drawing above), and
slide the clip onto the waistband of your clothing.
Follow the steps below to operate the console.
Insert the key fully into the power switch.
1
After a moment, the
four displays and one
indicator in the LED
track will light.
Monitor Displays
Before operating the
Key
Clip
¥ Adjust the speed in small increments.
¥ The settings marked above the speed control
(warm-up, fat burn, aerobic and performance)
are general guidelines only. See page 14 for
more information.
¥ To reduce the possibility of electric shock, keep
the console dry. Avoid spilling liquids on the
console and use only a sealable water bottle.
Reset the speed control.
2
Slide the speed
control to the
the RESET
position. Note:
Each time the
walking belt is
stopped, the
speed control must be moved to the RESET
position before the walking belt can be restarted.
Start the walking belt.
3
Slowly slide the speed control to the right until the
walking belt begins to move at slow speed. Step
onto the walking belt and begin exercising. Change
the speed of the walking belt as desired by sliding
the speed control.
To stop the walking belt, step onto the foot rails
and slide the speed control to the RESET posi-
tion. After a few seconds, the displays will pause.
8
LED Track
Speed Control