Table of Contents
Advertisement
Safety and operating instructions
Removing the old starter cord
1. Remove the three bolts from the protective cover
of the starting mechanism.
2. Lift off the cover, grasping the starter pulley as
well. Let the cover rotate carefully against the
starter pulley, to release the spring tension.
3. Remove the old starter cord.
Fitting a new starter cord
4. Oil the needle bearing in the starter pulley.
5. Fit the starter pulley and protective cover
together, so that the starting spring locates in
the starter pulley.
6. Wind the full length of the cord onto the pulley.
7. Pre-tension the starting spring by two thirds of
a turn (clockwise) before fitting the assembly
into place.
20
8. Pull the starting handle carefully, in order to
locate the cover correctly.
9. Fit and tighten the hexagonal bolts.
Troubleshooting
If the engine does not start, is difficult to start, runs
unevenly or has poor output, check the points
mentioned below.
♦
Check that the Stop button is in the ON position.
Check the fuel level.
♦
♦
Check the spark plug s electrode distance.
Check that the air filter is not blocked.
♦
Check that the fuel filter is not blocked.
♦
♦
When drilling, check that the flushing hole in the
drill steel is not blocked.
♦
When breaking, check that the 3.5 mm outlet hole
(A) is not blocked.
A
If the machine still does not work satisfactorily
♦
following these procedures, please contact your
nearest authorised Atlas Copco workshop.
Storage
Let the machine cool down before storing it.
♦
♦
Empty the tank before storing the machine.
Check that the machine is properly cleaned before
♦
putting it away for storage.
Store the machine in a dry place.
♦
We recommend to store the machine in a standing
♦
position. If stored in a lying position, the machine
must be placed on the back cover.
Keep the machine and tools in a safe place, out
♦
of the reach of children and locked up.
9800 1669 01 | Original instructions
CP Drill
Advertisement
Table of Contents
