Table of Contents
Advertisement
CP Drill
♦
For major service of the machine, contact the
nearest authorised workshop.
♦
For carburettor adjustments, contact the nearest
authorised workshop.
♦
After each service, check that the machine's
vibration level is normal. If not, contact the nearest
authorised workshop.
Every day
Before undertaking any maintenance or changing
the inserted tool, turn the machine off.
♦
Clean and inspect the machine and its functions
each day before the work commences.
Perform a general inspection and check that there
♦
are no leaks and no damage.
Check that the fuel cap gasket is undamaged and
♦
seals properly.
Check the electrical cabels and electrical
♦
insulations for wear, change if necessary.
Check the insertion tool, make sure that it is sharp
♦
and not worn out.
Change damaged parts immediately.
♦
♦
Replace worn components in good time.
In order to ensure that the machine remains within
the stated vibration level values, the following checks
must be performed:
Tool chuck check
If the chuck gauge provided can be inserted fully
across the flats of the chuck, this indicates that the
chuck is worn out and must be replaced.
Air filter check
In the event of continuos use, check and replace the
air filter at least every shift.
9800 1669 01 | Original instructions
Safety and operating instructions
1. Unscrew the air filter cover.
2. If the air filter is very dirty, it must be replaced.
Never wash the air filter.
3. Clean filter container.
Every third month
Check tightness of nuts, bolts, screws and hose
fittings. When retightening see the correct torque
settings in the spare part list.
Service
With continuous use of operation, leave the machine
for service according to the following service interval:
>
12 months of continuous use
Service must for safety reasons be performed by
authorised personnel at an authorised workshop.
Repair
Replacing the starter cord
WARNING
Spring tension
The starter spring may cause personal injury by
striking the operator or other persons.
►
Wear impact resistant eye protection with side
protection and gloves.
19
Advertisement
Table of Contents
