ProForm DTL42950 User Manual page 7

2. Attach the Left and Right Extension Legs (108, 109) with
four 1" Tek Screws (39) and two Base Pads (57) as
shown. Attach the lower Tek Screw, without the Base
Pad, first.
Attach the other two Base Pads (57) to the base of the
Uprights (69) with two 1" Tek Screws (39).
3. Insert the two Wheel Endcaps (65) into the base of the
Uprights (69) as shown. Attach the two Wheels (66) with
two Wheel Bolts (64) and two Wheel Nuts (32) as
shown. Do not overtighten the Wheel Bolts; the
Wheels should be able to spin freely.
With the help of another person, carefully raise the
Uprights (69) to the vertical position.
4. Identify the Right Handrail (72), which has a large hole in
the left side. Feed the Upright Wire (42) into the hole in
the bottom of the Right Handrail and out of the large hole
in the side. Note: It may be helpful to use needlenose pli-
ers to pull the Wire Harness out of the hole.
Attach the Right Handrail (72) to the right Upright (69)
with a Handrail Bolt (37).
Attach the Left Handrail (71) as described above. Note:
There is not a wire harness on the left side.
2
69
3
64
65
66
4
37
7
69
57
39
63
108
57
39
109
65
32
69
32
71
Hole
42
37
72
39
57
57
39
66
64
Hole
69