Engaging And Disengaging The Parking Brake - Toro TurfMaster 22205TE Operator's Manual

76cm walk-behind lawn mower
Hide thumbs Also See for TurfMaster 22205TE:
Table of Contents

Advertisement

1
Figure 20
1. Slide the control bar to the
right.
To disengage the self-propel drive and the blades, release
the control bar.
Note: You can vary the ground speed by increasing or
decreasing the distance between the control bar and the
handle. Lower the control bar to reduce the speed when you
make a turn or if the machine is moving too fast. If you lower
the control bar too far, the machine stops self-propelling.
Squeeze the control bar closer to the handle to increase the
ground speed. When you hold the control bar tight against
the handle, the machine self-propels at the maximum ground
speed.
Engaging and Disengaging the
Parking Brake
Engaging the Parking Brake
Engage the parking brake by pulling the brake lever up from
the handle
(Figure
21).
1
Figure 21
Parking brake engaged
1. Brake lever
2. Stop
Note: When the parking brake is engaged, the stop on the
control bar prevents you from raising the control bar to
operate the self-propel drive.
G019672
2
2. Raise the control bar to
the handle.
2
SUPERCEDED
3
g028360
3. Control bar
Disengaging the Parking Brake
Disengage the parking brake by pushing the brake lever down
to the handle
(Figure
1
g019672
Parking brake disengaged
1. Brake lever
2. Stop
Note: When the parking brake is disengaged and the control
bar is up to operate the self-propel drive, the stop on the
control bar prevents you from engaging the parking brake.
Recycling the Clippings
This machine comes from the factory ready to recycle grass
and leaf clippings back into the lawn. To prepare the machine
to recycle:
If the side-discharge chute is on the machine, remove it
and install the side-discharge deflector; refer to
the Side-Discharge Chute (page
If the grass bag is on the machine, remove it; refer to
Removing the Grass Bag (page
If the rear-discharge plug is not installed, grip it by
the handle, raise the rear door, and insert it into the
rear-discharge chute until the latch locks into place; refer
to
Figure
23.
g028360
1. Rear-discharge plug
13
22).
2
3
g028359
Figure 22
3. Control bar
15).
14).
G019812
Figure 23
2. Rear door
g028359
Removing
g019812

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents