Rear Panel - Onkyo CR-N775D Instruction Manual

> Before Start > Part Names

Rear Panel

    

90°
180°
> Install > Initial Setup
  
  
> Playback
Supplementary information | Advanced Setup | Others
1. SPEAKERS terminals: Connect speakers with the speaker cables.
2. Wireless antenna: Used for Wi-Fi connection or when using a BLUETOOTH
wireless technology enabled device. Adjust their angles according to the
connection status.
3. SUBWOOFER PRE OUT jack: Connect a subwoofer with built-in amplifier.
4. LINE OUT jacks: Connect a recording device, such as a cassette tape deck.
Connect to the LINE IN jacks on the recording device using analog audio cable.
5. LINE IN jacks: You can play the audio from an external device such as a television
connected with an analogue audio cable.
6. DAB/FM ANTENNA jack: Connect the supplied DAB/FM wire antenna.
7. NETWORK jack: Connect to the network with an ethernet cable.
8. jack: Connect an Onkyo product with an RI jack using an RI cable to
synchronize with this unit. ( P29)
9. AC INLET: Connect the supplied power cord.
10.USB port: Connect a USB storage device or HDD (hard disk drive) to play music
files. You can also supply power (maximum 5 V/1 A) to USB devices with a USB
cable. It is also possible to save or delete music files on the USB HDD with a
computer over the network. ( P33)
11. DIGITAL IN OPTICAL/COAXIAL jacks: You can play the digital audio from an
external device such as a television connected with a digital optical cable or a
digital coaxial cable.
5
En