Usb Storage Device/Hdd - Onkyo CR-N775D Instruction Manual

> Before Start > Part Names

USB Storage Device/HDD

1
2
> Install > Initial Setup
You can play music files by connecting a USB storage
device or HDD (hard disk drive) to the USB port on the
front or rear of the unit.
0 The USB port on the front supports a maximum 5 V/
0.5 A power supply. If the HDD requires more than
this, connect to the USB port (maximum 5 V/1 A) on
the rear of the unit.
Basic operations
Perform the following procedure when the unit is on.
1. Repeatedly press INPUT 2/1 on the remote
controller to switch input to USB Front or USB Rear.
2. Plug your USB storage device or HDD into the USB
port on the front or rear.
3. Press ENTER (e) after reading is complete.
4. Select the folder or music file with the cursors (c) of
the remote controller and press ENTER (e) to
confirm. To return to the previous display, press
(b).
0 Only the music files in the same level of the folder
are played.
5. Use play buttons (d) to stop play or choose tracks to
play.
> Playback
Supplementary information | Advanced Setup | Others
a
c
f
0 Press (a) to display information such as album
art and file format. The display of album name, artist
name, and album art is supported with WAV/MP3/
WMA/Apple Lossless/FLAC/AAC/DSD (DSF only)
format music files. The formats for embedded
images are JPEG and PNG.
0 With WAV format, to enable display of the artist
name, album name, and album art, follow the folder
structure and file naming as shown in the following
diagram when saving music files. The album art is
displayed by saving the .jpg files to be displayed in
the lowest folder. It may take some time for the .jpg
files to be displayed or they may not be displayed at
all if the volume of the data is large.
b
d
e
d
g
15
En