Fujitsu ETERNUS DX Configuration Manual page 19

Chapter 8 Setting Up Oracle VM Server
8.1 Setting Up the Fibre Channel Cards
6
Check the values that are set in the [Advanced Adapter Settings] window or [Adapter Settings] window.
The setting values vary depending on the type of Fibre Channel card used. Refer to the following table.
If the displayed values are different from those given in the following table, adjust them.
Refer to the Fibre Channel card manual and/or QLogic Corp. web-site for details.
• Parameter Settings List displayed in the [Advanced Adapter Settings] window or [Adapter Settings]
window
Parameter
Execution Throttle
LUNs per Target
Enable LIP Reset
Enable LIP Full Login
Enable Target Reset
Login Retry Count
Port Down Retry Count
Link Down Timeout
Extended Error Logging
RIO Operation Mode
Operation Mode
Interrupt Delay Timer
Enable Interrupt
EV Controller Order
7
Use an editor such as "vi" to add the setting values to the configuration file.
• Configuration file
OS
Oracle VM Server 3.3
Oracle VM Server 3.2
Oracle VM Server 3.1
Example
•
When "8" is set for "ql2xmaxqdepth"
options qla2xxx ql2xmaxqdepth=8
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle VM Server for x86
Setting value
2Gbit/s Fibre 4Gbit/s Fibre
Channel card Channel card
16 16
8 128
No
Yes
Yes
8
30
30
Disabled —
0 —
— 0
0
— No
— —
Configuration file
Any file (.conf) in /etc/modprobe.d/
/etc/modprobe.conf
/etc/modprobe.conf
19
Copyright 2017 FUJITSU LIMITED
Remarks
8Gbit/s Fibre
Channel card
65535 If the current pa-
rameter values
128
are different,
change them to
the indicated
values.
—
—
0
No
Disabled
P3AM-6612-14ENZ0