Siemens Sinumerik 840C Diagnostics Manual page 182

1 Alarms
1.5.1 Alarm description
165047 No curve parameterized
Scan
Copy to clipboard and paste from clipboard in the IKA relationships display selected "with" curve.
Effect
Function is not performed
S
Explanation
The curve number is not parameterized
S
Start or end pointer of the curve is not parameterized
S
The start pointer is greater than the end pointer
S
This information cannot be read (e.g. <on-line>, NCK power-up)
Remedy
Select "without" curve using the toggle key or press the Abort key and parameterize the curve.
Note
Applies as from SW 4
165048 No drift compensation performed for axis ...
Scan
"Drift compensation" softkey in Service display
Effect
Function not carried out.
Explanation
Internal error
Remedy
None
Note
Alarm in SW 5 and higher
165049 Axis ... not available
Scan
"Drift compensation" softkey in Service display
Effect
Function not carried out.
Explanation
The selected axis is not active, e.g. because it has just been set up.
Remedy
Perform Power on, repeat action.
Note
Alarm in SW 5 and higher
165050 Axis ... to be stopped first
Scan
"Drift compensation" softkey in service display
Effect
Function not carried out.
Explanation
Drift compensation only possible in Reset.
Remedy
Stop program, press Reset, repeat action.
Note
Alarm in SW 5 and higher
165051 NQFK data not backed up
Scan
"Save on hard disk" softkey in the File functions menu in the Diagnosis/Start-up/Machine data display
Effect
The NQFK data have not been saved
Explanation
System error
Remedy
Please notify Siemens Service
Note
Alarm in SW 5 and higher
165052 NQFK data for axis ... not saved
Scan
"Save on hard disk" softkey in the File functions menu in the Diagnosis/Start-up/Machine data display
Effect
The NQFK data for the stated axis have not been saved.
Explanation
The stated axis may have been incorrectly parameterized.
Remedy
Check parameterization and repeat procedure.
Note
Alarm in SW 5 and higher
1–174

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
04/96
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey