Table of Contents
Advertisement
C. CONNECT DRAIN HOSE
Benefit
for your
Proper connection of the drain hose
will protect your floors from damage
due to water leakage.
STEP 1. To prevent the drain hose from
coming off or leaking, it must be installed
per the following instructions:
IMPORTANT: To ensure proper installa-
tion, this procedure must be followed
exactly.
a. Wet the inside of the straight end of
the drain hose with tap water. DO
NOT USE ANY OTHER LUBRICANT.
b. Squeeze ears of silver, double-wire
clamp with pliers to open. Place clamp
over the straight end of the drain hose
1
/
inch from the end.
4
c. Open clamp. Twist hose back and
forth while pushing down onto drain
connector at the bottom of the washer.
Continue until hose contacts the
ribbed stop on the cabinet.
If you have:
Drain hose that is too short
Drain hose that is too long
A problem with lint clogging your drain
Parts listed are available from your local Sears store or Sears Service Center.
Call 1-800-366-PART (1-800-366-7278).
14
d. Place clamp over area marked
"CLAMP." Release clamp.
1/4"
You will need to buy:
Drain hose, Part No. 388423 and
hose kit, Part No. 285442
Hose kit, Part No. 285442
Drain protector, Part No. 367031
Drain Hose
1/4"
Clamp
Ribbed Stop
Cabinet
TWIST
AND
PUSH
1/4"
Advertisement
Table of Contents
