Advertisement
7
Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Transport the tool and batteries individually packaged.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
8
Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
8.1
The reciprocating saw is not in working order
Trouble or fault
The tool doesn't start.
The saw blade cannot be
removed from the chuck.
8.2
The reciprocating saw is in working order
Trouble or fault
The tool does not develop full
power.
The saw blade cannot be
removed from the chuck.
9
Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
Battery disposal
Improper disposal of batteries can result in health hazards from leaking gases or fluids.
▶ DO NOT send batteries through the mail!
Printed: 02.02.2018 | Doc-Nr: PUB / 5398518 / 000 / 00
Possible cause
The battery is not correctly in-
serted.
The battery is empty.
The transport lock is engaged.
The locking lever was not pushed
as far as it will go.
Possible cause
The control switch is not fully
pressed
The battery is discharged
The locking lever was not pushed
as far as it will go.
Action to be taken
▶ Push the battery in until it
engages with a click.
▶ Charge the battery.
▶ Disengage the transport lock.
▶ Push the locking lever as far as
it will go and remove the saw
blade.
Action to be taken
▶ Press the control switch fully.
▶ Change the battery and charge
the empty battery.
▶ Push the locking lever as far as
it will go and remove the saw
blade.
English
13
Advertisement
