Outline Of Operation Control By Microcomputer - Mitsubishi SRK13YJV-S Technical Manual & Parts List

7. OUTLINE OF OPERATION CONTROL BY MICROCOMPUTER

Operation and indication section for remote control
(1) Operation control function by remote controller
SRK10YJV-S
SRK13YJV-S
Remote controller
S Operation section
Operation section
FAN SPEED button
Each time the button is pushed, the
indicator is switched over in turn.
HI POWER/ECONO button
This button changes the HIGH POWER/
ECONOMY mode.
TEMPERATURE button
This button sets the room temperature.
(This button changes the present time and
TIMER time.)
ON TIMER button
This button selects ON TIMER operation.
SLEEP button
This button changes to SLEEP operation.
CLEAN switch
This switch changes the CLEAN mode.
Indication section
Unit display section
Unit indication section
SRK10YJV-S
CLEAN indicator
SRK13YJV-S
Indicates during CLEAN operation.
SLEEP indicator
Indicates during SLEEP operation.
TEMPERATURE indicator
HI POWER light (green)
Indicates set temperature.
(Does not indicate temperature when operation
Illuminates during HIGH POWER operation.
mode is on AUTO)
3D AUTO light (green)
FAN SPEED indicator
Illuminates during 3D AUTO operation.
Indicates set air flow rate with
How to open the air inlet panel
HI POWER/ECONO MODE indicator
Place fingers at the recesses on both sides of the panel and pull up the panel
Indicates during HIGH POWER/ECONOMY
to this side so that it will be opened by about 60 degrees.
mode operation.
Transmission procedure
When each button on the remote control is pressed with the remote control pointing towards the air-conditioner unit a signal is transmitted.
When the air-conditioner receives the signal correctly, it will beep.
RMA012A032_En.p65
How to close the air inlet panel
Push both sides evenly and press further lightly at the center.
Page 14
Page 12
Page 11
• The above illustration shows all controls, but in practice
only the relevant parts are shown.
Page 15
lamp.
7
Unit ON/OFF button
In emergencies, this button can be used for turning on/off the unit when
remote control is not available.
– 7 –

- -
04/05/2010, 17:26
OPERATION MODE select button
Each time the button pushed, the
indicator is switched over in turn.
ON/OFF (luminous) button
Press for starting operation, press again
for stopping.
AIR FLOW (UP/DOWN) button
This button changes the air flow (up/down) mode.
AIR FLOW (LEFT/RIGHT) button
This button changes the air flow (left/right) mode.
3D AUTO button
This button sets 3D AUTO operation.
OFF TIMER button
This button selects OFF TIMER operation.
Page 11
RESET switch
Switch for resetting microcomputer and
setting time.
CANCEL button
This button cancels the ON timer, OFF
timer, and SLEEP operation.
RUN light (green)
ON/OFF TIMER indicator
Illuminates during operation
Indicates during ON/OFF TIMER operation.
and CLEAN operation.
TIMER light (yellow)
Illuminates during TIMER operation.
OPERATION MODE indicator
Indicates selected operation with lamp.
(Auto) • (Cool) • (Fan) • (Dry)]
[
TIME indicator
Indicates present time or timer setting time.
AIR FLOW indicator
Shows selected flap and louver mode.
3D AUTO indicator
Indicates during 3D AUTO operation.
Page 15
Unit ON/OFF button
Page 10
Page 10
Page 10
Page 13, 17