Outline Of Operation Control By Microcomputer; Operation Control Function By Remote Controller - Mitsubishi SRK18CL Technical Manual & Parts List

7. OUTLINE OF OPERATION CONTROL BY MICROCOMPUTER

(1) Operation control function by remote controller

Remote controller
◆ Operation section
FAN SPEED button
Each time the button is pushed, the
indicator is switched over in turn.
HI POWER/ECONO button
This button changes the HIGH POWER/
ECONOMY mode.
TEMPERATURE button
This button sets the room temperature.
(This button changes the present time and
TIMER time.)
ON TIMER button
This button selects ON TIMER operation.
SLEEP button
This button changes to SLEEP operation.
CLEAN switch
This switch changes the CLEAN mode.
Unit display section
Unit display section
Unit ON/OFF button
This button can be used for turning on/off the unit when
remote control is not available.
Remote control signal receiver
ECONO light (orange)
IIIuminates during ECONOMY operation.
HI POWER light (green)
IIIuminates during HIGH POWER operation.
How to open the air inlet panel
Place fingers at the recesses on both sides of the panel and pull up the panel
forward so that it will be opened by about 60 degrees.
• The above illustration shows all controls, but in practice
only the relevant parts are shown.
Page 15

-
IIIuminates during operation.
Blinks at CLEAN operation .
CLEAN operation
IIIuminates during TIMER operation.
-
How to close the air inlet panel
Push both sides evenly and press further lightly at the center.
'12 • SRK-T-125
OPERATION MODE select button
Each time the button pushed, the
indicator is switched over in turn.
ON/OFF (luminous) button
Press for starting operation, press again
for stopping.
AIR FLOW (UP/DOWN) button
This button changes the air flow (up/down) mode.
OFF TIMER button
This button selects OFF TIMER operation.
RESET switch
Switch for resetting microcomputer and
setting time.
CANCEL button
This button cancels the ON timer, OFF
timer, and SLEEP operation.
RUN light (green)
3 sec.
ON
OFF
1 sec.
Page 15
TIMER light (yellow)