ProForm 745CS 831.299470 User Manual page 8

Proform user's manual treadmill
Table of Contents

Advertisement

If you purchase the optional heart rate monitor (see
page 19), follow the steps below to install the receiver in-
cluded with the heart rate monitor.
1. Make sure that the power cord is unplugged. Remove
the six or seven indicated Screws (46) from the back of
the Console Base (116).
2. Connect the Short Jumper Wire (B) to the wire on the
Receiver (A). Connect the other end of the Jumper Wire
to the PULSE jack on the back of the Console (see draw-
ing 2b). Next, peel the paper off the pad on the back of
the Receiver. Turn the Receiver so the cylinder is on
the side shown, and press the Receiver into the bottom
of the Console Base (116) in the location indicated by the
dotted line. Note: A Long Jumper Wire is included but will
not be used.
Make sure that no wires are pinched. Reattach the
back of the Console Base (116) with the Screws (46) (see
step 1 above).
1
2a
B
A
8
116
46
2b
116
PULSE
Jack

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

745cs831.299470

Table of Contents