Vehicle Application Information - Blizzard 760HD Installation Instructions & Owner's Manual

CAUTION
See your BLIZZARD ®
vehicle application recommendations before
installation. The Undercarriage Selection
Guide has specifi c vehicle and snowplow
requirements.
Vehicle application recommendations are based on
the following:
• The vehicle with the snowplow installed must
comply with applicable Federal Motor Vehicle
Safety Standards (FMVSS).
• The vehicle with the snowplow installed must
comply with the vehicle manufacturer's stated
gross vehicle and axle weight ratings (found on
the driver-side door cornerpost of the vehicle) and
the front and rear weight distribution ratio. In some
cases, rear ballast may be required to comply with
these requirements.
• BLIZZARD Undercarriage Selection Guide is
based on available vehicle capacity for snowplow
equipment on a representative vehicle equipped
with options commonly used for snowplowing and
with 300 lb of front seat occupant weight.
• Weights of front seat occupants can be adjusted
above 300 lb but vehicle with snowplow must not
exceed vehicle GVWR or GAWR.
• In some cases there may be additional limitations
and requirements.
• Installation, modifi cation and addition of
accessories must comply with published
BLIZZARD recommendations and instructions.
Available capacity decreases as the vehicle is
loaded with cargo or other truck equipment or
snowplow accessories are installed.
• If there is uncertainty as to whether available
capacity exists, the actual vehicle as confi gured
must be weighed.
Lit. No. B64090, Rev. 07

VEHICLE APPLICATION INFORMATION

outlet for specifi c
BALLAST REQUIREMENTS
as close to the tailgate
Ballast (additional weight) is an important part of
qualifying vehicles for snowplow eligibility. Rear
ballast must be used when necessary to remain in
compliance with axle ratings and ratios as specifi ed by
the vehicle manufacturer.
If ballast is required, it is important that it be secured
properly behind the rear axle. A ballast retainer kit is
available from your BLIZZARD outlet, PN 62849.
NOTE: The ballast retainer kit is for snowplow
vehicles requiring ballast. See your BLIZZARD
outlet for the correct amount of ballast required.
Include the weight of the retainer as part of the
ballast requirement. Sand bags are recommended
for use as ballast.
NOTE: Ballast recommended and its weight
calculations assume the entire width of the bed is
fi lled as close to tailgate as possible.
7
Position
and secure ballast
as possible.
June 15, 2010