Power Hitch™ System Instructions - Blizzard 760HD Installation Instructions & Owner's Manual

Prior to operating your straight blade snowplow, review
the Mounting and Dismounting Instructions label on
the back of the driver's side moldboard.
MOUNT INSTRUCTIONS
Read Owner's Manual for Complete Instructions.
STEP #1
CONNECT/DISCONNECT
POWER HITCH Switch
Pushbeam
Receiver
Mount Points
Kickstand Pin
Adjustable
Kickstand A-Frame
Mount Bushing
• Kickstand must be lowered, with kickstand pin seated in lower hole on pivot beam.
• Slowly drive vehicle forward until pushbeam receiver mount points contact
A-frame mount bushings.
• Turn POWER HITCH OPERATION switch (on plow control) to "ON" position.
• Connect plow and vehicle electrical harnesses. Connect weather caps together.
STEP #2
A-Frame
Latch
Lock Pin
A-Frame Latch
rotates clockwise
and hooks onto
Draw Pin
• Pull A-frame latch lock pin out and lower A-frame latch over draw pin.
• Push and hold CONNECT/DISCONNECT switch upward. POWER HITCH arm
will engage back of pushbeam and pull plow into pushbeam receiver mount
points on vehicle.
• Insert both hitch pins and secure each with hair pin cotter.
• Lower POWER HITCH arm to relieve tension on A-frame latch. Raise A-frame
latch and lock into position with lock pin. Raise plow.
• Raise kickstand until kickstand pin seats into upper hole on pivot beam.
U.S. Patents 5,638,618; 5,899,007; 6,178,669; 6,276,076; 6,393,737; 6,408,549; 6,412,199; 6,442,877; 6,615,513; Canadian and other patents pending.
Lit. No. B64090, Rev. 07
POWER HITCH™ SYSTEM INSTRUCTIONS
Undercarriage
Pushbeam
Slowly Move
Vehicle Forward
POWER
HITCH Arm
WARNING: Keep fingers away. POWER HITCH arm raises behind undercarriage pushbeam.
A-Frame
Hitch
Latch
Pin
Draw
Pin
NOTE: If at any time the Mounting and
Dismounting Instructions label, or any other label
attached to your snowplow becomes illegible,
promptly replace them.
DISMOUNT INSTRUCTIONS
Read Owner's Manual for Complete Instructions.
CONNECT/DISCONNECT
POWER HITCH Switch
Kickstand Pin
• Raise plow. Lower kickstand until kickstand pin is seated in lower hole on pivot beam.
• Lower plow on flat, level surface. Turn vehicle ignition off.
• Remove hitch pins from A-frame and undercarriage.
• Turn vehicle ignition on.
• Turn POWER HITCH OPERATION switch (on plow control) to "ON" position.
CONNECT/DISCONNECT
POWER HITCH Switch
Kickstand Pin
Adjustable
Kickstand
WARNING: Keep fingers away from plow and truck mounting points.
• Push and hold CONNECT/DISCONNECT switch downward. POWER HITCH
arm will disengage from behind undercarriage pushbeam and lower.
• Disconnect plow and vehicle electrical harnesses. Install weather caps.
• Turn SYSTEM POWER (on plow control) to "OFF" position.
• Slowly move vehicle backward away from plow.
30
STEP #1
Hitch
Pin
Adjustable
Kickstand
POWER
HITCH Arm
STEP #2
Slowly
Move Vehicle
Backward
POWER HITCH Arm
June 15, 2010
44812