Advertisement
99-5823CH
MAIN SCREEN TEXT CUSTOMIZATION
1. Press and hold the MAX A/C button for 10 seconds. The current home
screen will then be displayed and the cursor will appear and blink. It will
be located in the 1st location on the top row.
2.
To modify the text :
A. Use the FAN buttons to move the cursor forward or back. The
location where the cursor is blinking is the location that the
character may be changed.
•
FAN DOWN = Move Cursor ahead one location
•
FAN UP = Move Cursor back one location
B. To change the character where the cursor is currently blinking use
the TEMP buttons to progress through the character set.
•
TEMP UP = Show the next character
•
TEMP DOWN = Show the previous character
3. To exit this mode:
A. Do not press ANY buttons for 15 seconds and it will timeout
automatically.
B. Press button other than the 4 mentioned above.
4. To erase any changes made to the default display – Press and hold down
the recirculation button button for 15 seconds. The "TAURUS" will once
again be the default display.
NOTE : Characters are saved into memory immediately whenever changes
are made.
NOTE : While in this mode – no other display items will be updated.
99-5823CH KIT ASSEMBLY
FORD MUSTANG 2010-11
ISO DIN HEAD UNIT PROVISION
1
Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapters from
Metra and AXXESS to integrate your
new radio. Re-connect the negative
battery terminal and test the unit for
proper operation.
2
Mount the ISO Brackets to the head
unit with the screws supplied with the
unit. (Fig. A)
3
Snap the pocket into the bottom
opening of the radio housing.
(Fig. B)
4
Slide the head unit into the radio
opening until the side clips engage.
(Fig. B)
5
Snap the Trim plate into the Radio
Housing. (Fig. C)
6
Plug the A/C harness into the car side
of the climate control plug and the
other side into the kit
7
Reassemble dash in reverse order
of disassembly using the 99-5823CH
radio trim panel instead of the factory
radio trim panel.
A
B
C
Advertisement
