17. Feed Timing
Check:
1. Set the stitch length adjustment knob to "4".
2. Set the regulator wheel for the differential feed to "2".
3. Turn the handwheel in the normal direction and set the Front feed dog (D) so it comes
to its front top position and just before its starts to go to the back (A).
4. Put the needle clamp (41310 22- 01) on the needle bar and up against the machine's
housing and secure it .
5. Turn the handwheel in the opposite direction to the normal direction until the needle
clamp rests against the machine's housing.
6. The front Feed dog (D) should now have come to its highest position , just before the
feed dog goes to the front (B).
7. Both (A) and (B) positions should have equal height.
Setting:
1. Loosen the fastening screw (a) on the front feed dog.
2. Move the front feed dog unit (D) with eccentric (b) until the feed hight is the same on
both (A) and (B) positions.
3. Tighten the fastening screw (a) on the main feed dog.
4. Carry out a visual check.
A=B
20
A
B
a
b
D
1047306-26