Cornelius ED-250 BCP Operator's Manual page 13

Trouble
NO ICE DISPENSED FROM
ICE PORTION CONTROLLER ICE PORTION CONTROLLER
(CONTINUED)
NO ICE DISPENSED FROM
MANUAL ICE DISPENSE
PUSHBUTTON SWITCH
ICE DISPENSING DURING
AUTOMATIC AGITATION
Probable Cause
D. Insufficient or no CO
to dispenser.
E. Ice chute cover not properly
Installed.
F. Defective ice chute interlock
switch.
G. Defective interlock relay.
H. Defective 24V transformer.
I. Defective portion controller.
J. Defective ice gate cylinder.
K. Defective ice gate solenoid
valve.
L. Agitation relay wiring incorrect.
M. Defective agitation relay.
N. Defective agitator motor or
start capacitor or start relay.
A. Manual/Auto toggle switch in
"Auto" position.
B. Insufficient or no CO
dispenser.
C. Defective 24V transformer.
D. Defective manual override
solenoid valve.
E. Defective manual ice dispense
pushbutton switch.
F. Defective agitator motor or
start capacitor or start relay.
G. Defective ice gate cylinder.
A. Manual/Auto toggle switch in
"manual" position.
B. Defective ice gate cylinder.
C. Defective ice gate solenoid
valve.
D. Defective portion controller.
11
Enduro Ice/Beverage Dispenser Operator's Manual Enduro Ice/Beverage Dispenser Operator's Manual
supply D. Restore CO
2
E. Make sure that cover is "snapped"
into place.
F. Replace interlock switch.
G. Replace relay.
H. Replace transformer.
I. Replace controller.
J. Replace cylinder.
K. Replace solenoid valve.
L. Red wire should be connected to
"+" terminal (no. 3) of relay coil.
M. Replace relay.
N. Replace defective component.
A. Move toggle switch to "Manual"
position.
supply to B. Restore CO
2
C. Replace transformer.
D. Replace valve.
E. Replace switch.
F. Replace defective component.
G. Replace cylinder
A. Move toggle switch to "auto"
position.
B. Replace cylinder.
C. Replace valve.
D. Replace controller.
Remedy
supply to dispenser.
2
supply to dispenser.
2
620916502OPR