Cornelius ED-250 BCP Operator's Manual page 11

Sanitize syrup lines, BIB Systerms
1. Remove all the quick disconnects from all the BIB containers.
2. Fill a suitable pail or bucket with soap solution.
3. Submerge all disconnects (gas and liquid) in the soap solution and then clean them using a nylon bristle
brush. (Do not use a wire brush). Rinse with clean water.
4. Using a plastic pail, prepare approximately five (5) gallons of sanitizing solution.
5. Rinse the BIB disconnects in the sanitizing solution.
6. Sanitizing fittings must be attached to each BIB disconnect. If these fittings are not available, the fittings
from empty BIB bags can be cut from the bags and used. These fittings open the disconnect so the sanitiz-
ing solution can be drawn through the disconnect.
7. Place all the BIB disconnects into the pail of sanitizing solution. Operate all the valves until the sanitizing
solution is flowing from the valve. Allow sanitizer to remain in lines for fifteen (15) minutes.
8. Remove the nozzle and syrup diffuser from each valve and clean them in a soap solution. Rinse with clean
water and reassemble the nozzle and syrup diffuser to the valve.
9. Remove the sanitizing fittings from the BIB disconnects and connect the disconnects to the appropriate BIB
container. Operate the valves until all sanitizer has been flushed from the system and syrup is flowing free-
ly.
WARNING: If repairs are to be made to the beverage system, remove quick disconnects from the appli-
cable product tank, then relieve the system pressure before proceeding. If repairs are to be made to the
CO system, stop dispensing, shut off the CO
2
ing. If repairs are to be made to the ice dispensing system, make sure electrical power is disconnected
from the unit.
Enduro Ice/Beverage Dispenser Operator's Manual Enduro Ice/Beverage Dispenser Operator's Manual
supply, then relieve the system pressure before proceed-
2
9
620916502OPR