Assembly - Pro-Form PFEX39912 User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the crosstrainer in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed. In addition to the included
allen wrenches, assembly requires a phillips screwdriver
and a rubber mallet
As you assemble the crosstrainer, use the drawings below to identify the small parts used in assembly. The
number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page
22. The second number refers to the quantity used in assembly. Note: Some small parts may have been pre-
assembled for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.
M6 Flat M10 Zinc Split
Washer (71)–3 Washer (85)–2
M4 x 16mm
Screw (73)–1
M10 x 27mm Button
Screw (76)–3
1/2" Nylon
Locknut (52)–1
.
M10 Black Split
Washer (77)–3
M6 x 16mm
Screw (64)–5
M10 x 45mm Button
Screw (74)–2
M10 Nylon Black
Locknut (63)–2
M6 x 50mm Screw
(69)–3
M10 x 52mm Button Bolt (68)–2
M10 x 112mm Carriage Bolt (65)–2
1/2" x 70mm Bolt (51)–1
4
, an adjustable wrench
M10 Zinc Nylon
Locknut (66)–2
M6 x 25.4mm Button
Screw (79)–1