Toshiba dynaEdge DE-100 Series User Manual page 77

Problem
Battery does not
charge when the AC
adaptor is attached.
Battery does not
power the computer
as long as expected
Real-Time Clock
Problem
The BIOS setting
and system date/
time are lost.
User's Manual
Procedure
If the battery is completely discharged, it will not
begin charging immediately. In these instances,
wait a few minutes before trying again. If the
battery still does not charge, check that the power
outlet the AC adaptor is connected to its supplying
power. This can be tested by plugging another
appliance into it.
If you frequently recharge a partially charged
battery, the battery might not charge to its full
potential. In these instances, you should fully
discharge the battery and then attempt to charge it
again.
Check the Power saver option under Select a
power plan in the Power Options.
Procedure
If the RTC battery becomes completely
discharged, the real-time clock and calendar will
stop working. The RTC battery should be replaced
only by your dealer or by a TOSHIBA service
presentative, and then set the date/time in the
TOSHIBA Setup Utility by using the following
steps:
1. Launch the TOSHIBA Setup Utility.
Refer to the section for further information.
2. Set the date in the System Date field.
3. Set the time in the System Time field.
4. Follow the on-screen instructions to proceed.
6-6