ProForm 831.21522.1 User Manual page 7

8. Push down the seat lever (not shown) on the right side
of the Seat Carriage Assembly (10), slide the Seat
Carriage Assembly into the Seat Rail (78), and then
pull the seat lever back up.
Attach a Bumper (51) to the Seat Rail (78) with an
M4 x 20mm Screw (56). Next, press the Frame Rail
Endcap (50) into the end of the Frame Rail (52).
9. The Console (4) requires four 1.5V "D" batteries (not
included); alkaline batteries are recommended.
Remove the two battery covers from the Console.
Next, insert four batteries into the battery compart-
ments. Make sure that the batteries are oriented as
shown by the diagrams inside of the battery com-
partments. Then, reattach the battery covers to the
Console.
Attach the Book Holder (23) to the Console (4) with
two M4 x 12mm Screws (41) as shown.
10. While another person holds the Console (4) in the
position shown, connect the wire harness on the
Console to the Upper Wire Harness (42). Insert the
excess wire harness down into the Upright (2).
Attach the Console (4) to the Upright (2) with four M4
x 16mm Screws (57) and two Console Brackets (80).
Be careful to avoid pinching the wire harnesses.
8
56
51
78
52
9
23
4
10
80
57
2
7
Seat
Lever
10
50
Battery
Covers
41
Batteries
57
42
Wire
Harness
4