Quick Display Mode - La Crosse Technology TX231TH Instruction Manual

5.1 Quick Display Mode

- While in Normal Mode, press the SET key to enter the Quick Display Mode as follow:
1. Outdoor Temperature / Wind chill / Dew point (press the + key or MIN/MAX key shifts the display
between outdoor temperature, wind chill and dew point)
2. Absolute pressure / Relative pressure (press the + key or MIN/MAX key shifts the display between the
absolute pressure and relative pressure)
3. Wind speed / Gust speed (press the + key or MIN/MAX key shifts the display between the wind speed
and gust speed)
4. 1 hour/ 24 hour / week/ month / total rainfall quantity (press the + key or MIN/MAX key shifts the display
between the selectable rainfall quantities), while display the rainfall total quantity, pressing the SET key
for 2s will reset the rainfall total value to zero and the time recording to current time
- Press the SET key to accept the change and advance to the next display mode. Continue to press the SET
key to toggle through the display mode until return to the normal Mode
5.2 Setting Modes
- Press the SET key for 3 second while in normal mode to enter the normal Setting mode
Press the SET key to select the following setting in sequence :
-
1. Time Zone Setting
2. DST on/off
3. 12/24 hour format
4. Manual time setting (hours/minutes)
5. Calendar setting(year/month /date)
6. Temperature display unit degree Celsius or Fahrenheit
7. Air pressure display units in hPa or inHg
8. Relative pressure setting from 27.13inHg – 31.89inHg (default 29.93inHg)
9. Pressure threshold setting (default 3)
10. Storm threshold setting (default 5)
11. Wind speed and gust display units in km/h, mph, m/s, knots, bft
12. Rainfall display units in mm or inch
In the setting modes, press + key or MIN/MAX key change or scrolls the value. Holding the + key or
-
MIN/MAX key for 3 second will increase/decrease digits in great steps.
Press HISTORY key or key idle 30 second, the setting mode will return to Normal Mode
-
Note: Please set the units firstly before change units' value. During change of units setting, units' value will
change according to new units but it might cause resolution loss due to its internal calculation algorithm.
Note: "DST OFF" indicates that the feature is off and the internal real time clock will not change times
automatically. "DST ON" indicates that the feature is on and the internal real time clock will change times
according to the DST time schedule automatically. Some locations (Arizona and parts of Indiana) do not
follow Daylight Saving Time, and should select "DST OFF".
5.3 History Modes
While in Normal Mode, press the HISTORY key to enter the History Mode.
-
In the History Mode, press the + key to select the record over the past 24hours at increments of -3 hours,
-
-6 hours, -9 hours, -12 hours, -15 hours, -18 hours, -21 hours, -24 hours
-
Press the HISTORY key or key idle 30 second to return to Normal Mode
5.4 Alarm Modes
- While in Normal Mode press the ALARM key to enter the High Alarm Mode
- Press the ALARM key again to enter Low Alarm mode
Remark: after the initial pressing of ALARM key, the display will be refreshed to show current high, low alarm
values. Normal alarm value will be displayed only for those already activated, all other not activated
values will be displayed with "- - -"or "- -"instead.
- Press the ALARM key again to return the Normal Mode
- In the High Alarm Mode press the SET key to select the following alarm modes:
7
.