Napoleon EPI3 Installation And Operating Instructions Manual page 17

5.4 SURROUND INSTALLATION, CONTEMPORARY CAST
Line up the casting holes with the right retaining bracket holes and secure in place using
A.
the 1/4-20 hex-head screws. Repeat on the left side, using the left retaining bracket (FIG 1, A).
Thread the 1/4-20 round-head screws approximately half their length into the keyed
B.
bracket (FIG 1, B).
Place the casting pieces face down on a protected surface and assemble as shown (FIG 2).
C.
D. Fasten the securing brackets using the screws (FIG 2, C).
Secure the corner brackets into place on both sides of the casting using the
E.
screws (FIG 2, D).
Lift the casting, place the keyed holes onto the 1/4-20 round head screws, and rest the casting into
F.
place (FIG 2). Adjust screws as necessary to stabilize.
NOTE: To ensure the joints are flush, adjustment may be necessary. To adjust the cast components,
loosen the screws and then align the casting to desired position.
FIG. 1
D
FIG. 2
B
B
1/4-20 ROUND
HEAD SCREWS
A
A
RETAINING
BRACKET
SECURING
BRACKET
CORNER
BRACKET
KEYED BRACKET
(LEFT & RIGHT)
C
W415-1773 / A / 11.23.17
17
EN