Napoleon EPI3 Installation And Operating Instructions Manual page 16

16
5.3 SURROUND INSTALLATION, TRADITIONAL CAST
Place the 2 side castings and the centre casting face down on a protected surface and assemble as
A.
shown (FIG 1).
EN
Line up the casting holes with the casting bracket holes and secure in place using the screws. Secure
B.
the casting support to the casting bracket using the screws (FIG 1, A).
Loosely secure the screws to the holes in the side casting (FIG 1, B). Repeat on the other side.
C.
Using screws, secure the 4 retaining brackets in place (FIG 2, C).
D.
Lift the casting, place the screws into the retaining brackets, and tighten fully (FIG 2, D).
E.
NOTE: To ensure the joints are flush, adjustment may be necessary. To adjust the cast components,
loosen the screws and then align the casting to desired position.
FIG. 1
FIG. 2
W415-1773 / A / 11.23.17
B
A
C
D