Getting Started; Setting The Correct Time - Altec Lansing timeMachine IMW465 Owner's Manual

Getting Started

Before you begin using your timeMachine Wireless Alarm Clock Speaker, you must make sure to connect it to
a power supply. Connect one end of the included AC adaptor (10V 2.4A) to the DC jack located on the back
of your unit. Connect the other end into a suitable power outlet in your home.

Setting the Correct Time

In order to use your device as an alarm clock, you will need to make sure it is set to display the correct time.
To do so, follow the steps below.
1. Press and hold the TIME SET button for 2 seconds until the clock's display begins to flash.
2. Press the +
time) setting.
3. Press the TIME SET Button again to enter the clock setting mode and bring up the clock hours
4. Press the +
setting).
5. Press the Time Set Button again to bring up the clock minutes.
6. Press the +
setting).
7. Press the TIME SET button to confirm the time and exit clock setting mode.
8. Congratulations! You have successfully set the time.
Notes: setting the clock must be on standby mode.
or –
buttons to alternate between the 12H setting (standard time) or the 24H (military
or –
Buttons again to adjust the clock hours to the current time (hold for rapid
or –
Buttons again to adjust the clock minutes to the current time (hold for rapid