Run A Barcode Demo Test
IMPORTANT
Printronix recommends using the supplied roll of 100 labels to
set up and verify printer operation. If you have an SL5000r, this
will avoid expending the more expensive smart labels for this
task.
Before you send an actual print job, run a bar code demo test:
1. Press the PAUSE key until OFFLINE displays.
2. Press TEST PRINT until Printer Tests / Barcode Demo
3. Press
4. Check the test pattern. If necessary, reposition the pressure
5. If desired, you can run additional printer tests, such as Grey,
NOTE: These tests run continuously by default. Press
displays.
↵
. The Barcode Demo test pattern will start and print two
bar codes.
blocks to obtain a uniform print quality. In most cases, you will
need to adjust only the right pressure block.
Grid, and Checkerboard. See step 1 above to start other tests.
test.
QUICK SETUP Menu Items
↵
to end the
53