Selecting A Form Already Loaded In The Tractors; Loading A New Or Different Form In The Tractors - Printek 850 Series Operator's Manual

Selecting a Form Already Loaded in the Tractors

To select a form that is already physically in the tractors, take the printer off
line and press the UNLOAD/CHANGE button until that form is displayed (a
form that is not considered to be loaded will flash
bottom line of the display). The form selection will be displayed as FORM
0 through FORM 9 or as the actual name of the form if that has been set
up.
To position the form for printing, you may press the LOAD/FEED button,
which will position the form, or you may press the ONLINE button, which
will both position the form and place the printer on line.

Loading a New or Different Form In the Tractors

This section describes how to "load" a form in the tractors. This involves
physically placing the paper or form in the tractor mechanism and then
informing the printer that the new form is present.
Select the Form to be Loaded
1. Take the printer off line by pressing the ONLINE button. The ONLINE
indicator should now be flashing red.
2. Press the UNLOAD/CHANGE button. This will move the current form
from the print position to the tractors for removal.
3. Continue to press the UNLOAD/CHANGE button until the desired form
name is shown on the top line of the display. The form name will
be FORM 0 through FORM 9 or the actual name of the form if
the name has been set in SETUP. If the desired form is not
considered to be "loaded" by the printer,
flash on the bottom line of the display.
Loading the Form in the Tractors
(Refer to "
PrintMaster 850/850si Single Tractor Model
2 6
D A I L Y O P E R A T I O N
Not Loaded
<
Not Loaded
<
" page 12)
>
on the
> will