Selecting And Loading Forms; Selecting A Form Already Loaded In The Tractors; Loading A New Or Different Form In The Tractors - Printek 4000se Operator's Manual

Selecting And Loading Forms

Note: A form is not considered "loaded" by merely placing the
form in the tractors. To prevent printing on the wrong
form, the printer must be made aware of what form(s)
are currently loaded. When a new form is placed in the
tractors, the form must be "loaded" using the control
panel as described in the next section, "Loading a
Different Form in the Tractors".

Selecting a Form Already Loaded In the Tractors

To select a form that is already loaded in the tractors, take the printer off
line and press the FORM SELECT button until that form is displayed (a form
that is not considered to be loaded will flash Not Loaded on the bottom
line of the display). The form selection will be displayed as FORM 0
through FORM 9 or as the actual name of the form if that has been set up.
To position the f orm for printing, you may press the FORM FEED button,
which will position the form, or you may press the ONLINE button, which
will both position the form and place the printer on line.

Loading a New or Different Form In the Tractors

This section describes how to "load" a form in the tractors. This involves
physically placing the paper or form in the tractor mechanism and then
informing the printer that the new form is present.
Select the Form to be Loaded
1. Take the printer off line by pressing the ONLINE button. The
ONLINE green indicator would now be turned off.
2. Press the UNLOAD/FORM SELECT button. This will move the
current form from the print position down to the tractors for
removal.
D A I L Y O P E R A T I O N
25