Table of Contents
Advertisement
Figure 6 Mounting and grounding positions of the HP 5700-48G-4XG-2QSFP+/HP
5700-48G-4XG-2QSFP+ TAA/HP 5700-40XG-2QSFP+/HP 5700-40XG-2QSFP+ TAA switch
1
(1) Auxiliary grounding point 2
(3) Primary grounding point
(5) Front mounting position
Attaching the mounting brackets and chassis rails to the chassis
1.
Align the mounting brackets with the screw holes in the rear mounting position (see
front mounting position (see
2.
Use M4 screws (supplied with the switch) to attach the mounting brackets to the chassis.
3.
Align the chassis rails with the rail mounting holes in the chassis:
If the mounting brackets are in the rear mounting position, align the chassis rails with the screw
holes at the front of the side panels (see
If the mounting brackets are in the front mounting position, align the chassis rails with the screw
holes at the rear of the side panels (see
4.
Use M4 screws (supplied with the switch) to attach the chassis rails to the chassis.
NOTE:
Secure the mounting brackets and chassis rails to both sides of the chassis in the same way.
Connecting the grounding cable to the chassis
CAUTION:
The primary grounding point and auxiliary grounding point 1 are located on the left side panel. If you use
one of these grounding points, you must connect the grounding cable to the grounding point before you
mount the switch in the rack.
To connect the grounding cable to a chassis grounding point, for example, the primary grounding point:
1.
Choose a grounding point.
2.
Unpack the grounding cable and grounding screws.
3.
Align the two-hole grounding lug at one end of the cable with the grounding holes of the
grounding point, insert the grounding screws into the holes, and tighten the screws with a
screwdriver to attach the grounding lug to the chassis, as shown in
(2) Rear mounting position
(4) Auxiliary grounding point 1
Figure
8).
Figure
Figure
8).
10
2 3
7).
Figure
4 5
Figure
7) or
7.
Hide quick links:
Advertisement
Table of Contents
