Table of Contents
Advertisement
5
p
r o g r a m m i n g
5.1 p
r e pa r at i o n
• Connect the digital module to a programmed modulator module.
• Connect the test receiver to the HF output on the modulator module.
• Adjust the test receiver to the output channel of the channel strip to be set:
Digital module – channel strip "A" —> modulator module – channel strip "A",
Digital module – channel strip "B" —> modulator module – channel strip "B",
Digital module – channel strip "C" —> modulator module – channel strip "C",
Digital module – channel strip "D" —> modulator module – channel strip "D".
• Switch on the modulator if necessary. For each modulator, there is a green
LED which indicates if the modulator is switched on.
—> For the programming of the output channels please read the assem-
bly instructions of the corresponding modulator module.
LED – Channel strip "A"
LED – Channel strip "B"
LED – Channel strip "C"
LED – Channel strip "D"
- 12 -
CGS 470
Advertisement
Table of Contents
