Comfort Adjustments; Seat Height And Seat Angle Adjustment; To Change The Seat Height; Seat Height And Angle Adjustments - Pride Mobility Jet 7 Owner's Manual

V I . C O M F O R T

COMFORT ADJUSTMENTS

After becoming familiar with your power chair's operation, you may find the need to make some adjustments to increase
your comfort, such as seat height and angle, armrest angle, foot platform height and angle, and controller position.
WARNING! If your power chair was configured by your authorized Pride Provider, please consult
your healthcare professional before changing the seat position or making any other adjustment.
Some adjustments may degrade your power chair's performance and safety by changing its center
of gravity.
WARNING! Some power chair components are heavy. You may need assistance to lift or carry
them. Please refer to the specifications table for specific component weights before you
disassemble the power chair.
WARNING! Prevent injury. Remove the occupant from the power chair before making any
adjustments.
You may need the following to make comfort adjustments:
! metric/standard socket set and ratchet
! adjustable wrench
! metric/standard hex key set

Seat Height and Seat Angle Adjustment

The seat is attached to the power base through the UMS.
You can change the seat height by raising the front and rear
trapeze bars. If you raise or lower only one trapeze bar (front
or rear), you can also change the seat base angle (dump).

To change the seat height:

1. Turn off the power to the controller.
2. Disconnect the controller from the electronics tray.
3. Flip up the seat latch safety. See figure 13.
4. Squeeze the seat latch and release the seat from the front
trapeze bar.
5. Slide the seat forward and remove it from the power
base.
6. Remove the ball detent pin from each seat post. See
figure 21.
7. Raise or lower each trapeze bar to the desired position.
8. Reinstall the ball detent pin into each seat post.
9. Reinstall the seat onto the trapeze bars.
WARNING! Make sure the seat latch
safety is flipped down before using your
power chair.
10. Connect the controller to the electronics tray.
Jet 7
A D J U S T M E N T S
TRAPEZE BARS
SEAT POST
Figure 21. Seat Height and Angle Adjustments
www.pridemobility.com
BALL DETENT
PIN
23