Pride Hurricane PMV Owner's Manual page 33

V I I I .
POWER SEAT (OPTIONAL)
Your PMV may be equipped with a power seat option, a power seat switch will be located on the tiller console. See
figure 5. The power seat will be equipped with one of two operating systems. Refer to figures 14 and 15 to
determine which system your PMV uses and follow the appropriate instructions for safe operation.
WARNING! The power seat is intended for operation only while your PMV is stationary and
on a level surface. Its purpose is to aid you in reaching objects. Drive your PMV only with
the power seat in the lowest position. Driving the PMV with power seat elevated could
result in personal injury, equipment and/or property damage.
Strict adherence to the following safety rules is vital to your safety:
Operate the power seat only while completely stationary on level ground.
Do not press the throttle control lever and the power seat switch at the same time.
Do not operate your PMV with the power seat elevated. Operate the PMV only with the
power seat fully retracted (in the lowest position.
Never place your PMV in freewheel mode with the power seat elevated.
Use extreme caution when reaching for objects with your power seat elevated. Do not
overextend or attempt to pick up objects that might affect your balance.
Do not attempt ot raise or lower the seat while in motion.
Before operating the power seat, ensure your PMV is level and stationary and the speed adjustment dial is set to
the slowest setting.
System 1 - Operation using power seat switch
and throttle control lever:
1. Release the throttle control lever.
2. Toggle the power seat switch located on the tiller
console to the "on" position. See figure 14.
3. To raise the power seat, operate your throttle con-
trol lever in the forward direction.
4. Release the throttle control lever when you have
attained your desired height.
5. To lower the power seat, operate your throttle
control lever in the reverse direction.
6. Ensure your seat is in the lowest position and that
you have fully released the throttle control lever.
7. Toggle "off" the power seat switch before you at-
tempt to drive your PMV again.
THROTTLE CONTROL LEVER
Figure 14. Power Seat Switch (With Vertical Line And
Circle) Used In Conjuction With Throttle Control Lever to
Activate The Power Seat Actuator (Switch Shown In The
"Off" Position)
Hurricane
C O M F O R T
400/181
www.pridemobility.com
A D J U S T M E N T S
System 2 - Operation with power seat switch only:
1. To raise the power seat, press and hold the upper
part of the switch. Release the switch when you have
attained your desired height or until reaching the high-
est position. See figure 15.
2. To lower the power seat, press and hold the lower part
of the switch. Release the switch when you have attained
your desired height or until reaching the lowest position.
NOTE: The PMV must be stopped in order for the power
seat to be operated. If the power seat switch is pressed
while the PMV is in motion, the PMV will slow and come
to a stop. The PMV may also produce a fault code indi-
cated by the Status LED on the console. If a fault code
occurs, you will need to turn the PMV's power off then
back on again before proceeding.
Figure 15. Power Seat Switch (With No Markings)-Acti-
vates The Power Seat Actuator
33