Scope Of Delivery - Dimplex ECS150HP40A-580 Installation And User Instructions Manual

Precaution: This appliance can be used
by children aged from 8 years and above
and persons with reduced physical,
sensory or mental capabilities or lack of
experience and knowledge if they have
been given supervision or instruction
concerning use of the appliance in a safe
way and understanding the hazards
involved. Children shall not play with the
appliance. Cleaning
maintenance shall not be made by
children without supervision.
Note: Between the inlet group and
the cold water inlet on the cylinder
NO isolating device may be fitted, as
by doing so important safety devices
could be isolated!
It is important to check the pre-
charge pressure of the expansion
vessel membrane before filling the
cylinder. This has been factory set
to 3 bar. The pre-charge should be
greater than or equal to 3 bar.
It is important that the tundish is
positioned away from any electrical
components.
Note: Means
disconnection must be incorporated
in the fixed wiring in accordance
with the wiring rules.
Before removing the cover from the
immersion heater isolate appliance
using isolating switch! Danger of
electrical shock! Only use suitable
electrically insulated
when working inside immersion
housing.
and user
for electrical
equipment

Scope of Delivery

The maintenance
appliance must be carried out by
a suitably qualified person only.
It is recommended to maintain
the unit on an annual basis.
Isolate all
from the unit before commencing
work. Danger of electrical shock!
CLEANING
Clean outer cladding of cylinder
with a soft cloth dampened with
warm water only. Do not use
abrasive or aggressive cleaning
materials, such as alcohol or
petroleum based solvents, as
this may damage the surface of
the product.
Temperature setting: A high level
cutout is fitted to the product for
each heat source. This should never
activate under normal operation.
The maximum
temperature attainable by the heat
pump is 65°C as set on the User
Interface. The back-up immersion
heater can produce up to 72°C at its
maximum setting,
convenience the immersion heater
is preset to produce 60°C.
If an electronic copy of this manual
should be required, please contact the
manufacturer at the address at the back
of this manual.
of this
electrical supplies
INSTRUCTIONS:
possible cylinder
i.e. 5. For