Selecting Jacks For External Output - Sony PXW-Z90T Operating Manual

Connecting to a monitor or a TV (Continued)
• When the frame rate in [REC FORMAT] is set to 24p or 30p (when [60i] is selected) or 25p (when [50i]
is selected), the output signal is converted to interlace or progressive through pull-down conversion.
• Do not connect the output jacks of the camcorder with the output jacks of the monitor or TV. A
malfunction may be caused.
• If you display the edit screen while outputting signals to a monitor or TV, the menu may not be displayed
correctly.
• This camcorder is not compatible with "BRAVIA" sync.
• Make sure that the Earth connection between the camcorder and external devices is securely grounded
before turning on the power.
(It is recommended that the camcorder and external devices be turned on after connecting the 75 Ω
coaxial cables.)
If you need to connect an external device with devices in the powered state, connect the 75 Ω coaxial
cable to the external device and then connect to the camcorder.

Selecting jacks for external output

Select (REC/OUT SET) t [VIDEO OUT] t [OUTPUT SELECT] t [OUTPUT
SELECT] t desired output destination.
b Note
• If the file format is AVCHD, MPEG HD, or XAVC HD and [OUTPUT SELECT] is switched to [SDI],
then [NIGHTSHOT LIGHT] is set to [OFF]. For more information, see "Recording" (p. 31).
70