Table of Contents
Advertisement
System Installation
When installing the camera, check the reception of the monitor before final
installation. Have someone hold the camera in the area to be monitored. Have
another person move the monitor to a variety of locations throughout the house
to check the reception. If interference or any other problems occur, refer to the
"Troubleshooting" section of this manual.
To install the system follow these steps:
Monitor:
1. Plug the 5V AC/DC adapter cord into the DC output jack on the side of the
monitor.
2. Plug the adapter into a standard (110V - 240V) AC wall outlet. Press the power
button to turn on the monitor.
3. A/V outputs on the LCD monitor can be connected to the A/V input on a TV set
for the large screen display, or to the A/V inputs on a VCR for recording.
4. You can use the AC/DC adapter for long time use or four "AAA" batteries for
mobile use. The lifetime of four "AAA" batteries in use is 45 minutes.
Camera:
1. Plug the 7.5V AC/DC adapter cord into the DC input jack on the back of the
camera.
2. Plug the adapter into a standard (110V - 240V) AC wall outlet.
3. You can use the AC/DC adapter for long time use or two "AA" batteries for
mobile use. The lifetime of two "AA" batteries in use is 1.5 hr w/o IR function
and 1 hr with IR function.
System Setup:
1. Select a channel (Channels 1-4) to be
used on both the camera and the receiver.
NOTE: Make sure both the camera and
the receiver are set to the same channel
(1, 2, 3, or 4) and that the camera
is turned to the on position.
2. Select the desired channel by gently pushing
the dip switch to the same channel number
on both the camera and the receiver.
For example, to set both the camera and receiver on Channel 1:
Push the Channel 1 dip-switch located on the side of the camera and
the receiver to the same number.
3. For the baby monitoring feature, place the camera's "ON/OFF" switch to the
"OFF" position on the transmitter unit.
NOTE: Make sure the camera and receiver are set to the same channel
number first.
CH
CH1 CH2
Camera
Receiver Set
Set to
to Channel 1
Channel 1
CH4 BAT.LOW
CH3
5
Advertisement
Table of Contents
