Table of Contents
Advertisement
Disposal
If the camera system no longer functions properly and cannot be repaired, it must
be disposed of according to valid statutory regulations for your area.
Disposing of spent batteries and toxic materials
All batteries, accumulators and toxic substances must be recycled
properly. They are not to be disposed of in regular household waste but to
a collection point in your community area. Abbreviations for the respective
heavy metals can be found on the side of the product(s) and are shown as:
Cd = cadmium, Hg = mercury and Pb = lead.
Troubleshooting
You can easily fix any problems or malfunctions.
Observe the safety notices under all circumstances!
Error
No image and no sound
The image/sound is distorted
Flickering/running image
Normal sound, but image is too
light or too dark.
White image only on the monitor
ATTENTION!
All other repairs not described above should only be performed by an authorised
Repair Centre.
8
Possible Cause
• Camera or monitor not supplied with electricity
• Power source is plugged in incorrectly or the
batteries are drained
• Distance between camera and receiver is too large.
• The same channels are not set on the camera and
the receiver
• System's range between camera and receiver was
exceeded.
• There is a strong interference source nearby.
• Distance between units is too short and may over
steer the receiver. Increase the distance.
• The supply voltage is too low (change batteries).
• Strong spotlight in the cover range of the camera
• Adjust the vertical hold.
• The monitoring range of the camera is not lit properly
• Surveillance monitor is adjusted wrong.
(readjust contrast or brightness).
• Strong spotlight in the cover range of the camera.
• The supply voltage is too low (change batteries or
power pack operation).
• The surveillance monitor is not correctly adjusted
(brightness controller).
Advertisement
Table of Contents
