Connecting the Camera
Connect the small voltage plug of the power unit to the voltage supply jack of the
camera. Pay attention to the correct output voltage of 7.5V DC!
• Insert the plug-in power unit into a suitable wall outlet.
• The camera is now ready for use.
Installing the Receiver
Install the monitor approx. 3' (1 m) above ground (for better reception). A wall
outlet should be near by.
ATTENTION!
Place the monitor on a sturdy, stable surface. If the surface is delicate, use a suitable
underlay to protect it from damage.
1
2
3
4
5
6
POWER ON
SCREEN ON
POWER OFF
Connecting the Receiver
4
8
CH1 CH2
CH3
1 VOL. Control
2 Brightness Control
3 CH Select
4 A/V Output
5 LCD Power ON/OFF
• Connect the AV cable as shown to a suitable monitor
or TV system with an AV cinch input and the receiver
(white/red plug = audio (tone in mono), yellow plug =
video.
• Connect the small voltage plug of the power unit to the
voltage supply jack of the receiver. Pay attention to the
correct output voltage of 5V DC!
• Insert the plug-in power unit into a suitable wall outlet.
• The receiver is now ready for use.
• See the System Installation section for battery
instructions.
7
9
BAT.LOW
CH4
6 DC Power
7 Antenna
8 Channel LED
9 BAT.LOW LED
10 Power adaptor plug with
low voltage switch
11 A/V Cable
11
10