Installing The Camera; Installing And Connecting The Devices - NexxTech CCD-420 User Manual

Installing the Camera

ATTENTION!
Prior to drilling and inserting the screws, make sure that there are no electric cables pipes,
etc. in the wall that could be damaged.
1
2
3
PWR. BAT.LO
4
5
POWER
6
ON/OFF
1 Antenna
2 Low battery indicator
3 Power indicator
4 Eye ball camera lens
5 Power ON/OFF switch
6 Microphone

Installing and Connecting the Devices

Select a suitable installation site from which you can monitor the desired area.
A suitable installation site has the following features:
• dry
• good air circulation
Select an installation site that is not screened off by reinforced concrete walls, mirrors, metal
shelves, etc.
There should not be any appliances with strong electric fields close to the sender or the receiver.
The above points could severely impair radio transmission and reduce the units field 16' (5m) range.
Fastening the wall bracket
9
7
10
8
CAMERA
ON/OFF
7 IR LED
8 Camera ON/OFF switch
(camera kit/baby monitor)
9 Channel switch
10 DC Power
11 Power adaptor plug with low voltage switch
• as dust-free as possible
• a wall outlet in close vicinity
wall mount slot
attach stand to
mounting surface
battery
compartment
11
• few vibrations
• Look for a suitable place
for mounting
(with a socket near-by).
• Screw the wall bracket with the
supplied screws to a suitable
wall or platform, using dowels
if relevant.
• Align the camera and screw the
corrugated plastic sleeve tight.
• See the System Installation
section for battery instructions.
3