Precor 776i Owner's Manual page 32

Table 6. Informational Displays
Product Display
O D O M E T E R
All
H O U R M E T E R
All
U - B O O T S W
All
U - B A S E S W
All
L O W E R S W
All
M E T R I C S B O A R D S W P A R T N U M B E R
534i, 532i,
AMT
S T R I D E D I A L S W P A R T N U M B E R
AMT
S E R . N U M B E R
All
U S A G E L O G
All
E R R O R L O G
All
Product Owner's Manual: Club Features
Description
The odometer value correlates to the type of Precor product and the standard of units, U.S. or
Metric, selected in the club programs.
Treadmill shows the number of cumulative miles or kilometers logged to date.
EFX or AMT shows the number of total strides logged to date.
Cycle shows the number of total revolutions logged to date.
Climber indicates the number of floors climbed.
The number of hours that the equipment has been in use. The equipment tracks the elapsed
minutes, but the value that appears is truncated to the nearest full hour.
Upper board application software part number and version.
U P P E R B O O T S W P A R T N U M B E R
Note: Some displays show
Upper base application software version.
U P P E R B A S E S W P A R T N U M B E R
Note: Some displays show
Lower application software version.
L O W E R B A S E S W P A R T N U M B E R
Note: Some displays show
Metrics board software part number and version.
Stride dial software part number.
The serial number is helpful when you contact Customer Support. You can also find the serial
number located on a label on the front hood (treadmills) or optional power receptacle (self-powered
equipment) if one does not appear in the display.
S E R I A L N U M B E R
Note: Some displays show
The software logs the number of times each program has been used and displays the associated
cumulative minutes. The usage log is helpful in determining user preferences in program selection.
The error log displays any error codes that may have been detected by the software. Copy the error
code information to paper so you can provide it to Customer Support, if needed. Be sure to copy it
exactly as shown. Refer to Error Log.
.
.
.
.
30