Using Smartrate - Precor Commercial Adaptive Motion Trainer C100i User's Reference Manual

Using SmartRate

The SmartRate feature helps you monitor and maintain your heart rate
in the target zone best suited to your specific needs. When the AMT
detects a heart rate, a single LED blinks and indicates the zone that
your heart rate is in.
Important: To use the SmartRate feature, you must enter your age
during the setup phase of your exercise session.
The 10 LEDs in the SmartRate display are color-coded. Pulsating
orange LEDs indicate you are exercising outside the recommended
heart rate target zone. Green LEDs indicate when you are exercising
within the recommended fat burn or cardio fitness zones.
Table 1 shows the percents used in calculating the heart rate target
zones. While your heart rate remains within these zones, the
corresponding light blinks and provide a visual cue.
The calculation used to determine your maximum aerobic heart rate is
(220 minus your age). When you multiply it by the percent indicated in
Table 1, you can understand the relationship between the pulsating
LED and your target heart rate.
CAUTION: Your heart rate should never exceed 85% of your
maximum aerobic heart rate or go above PEAK. If it does,
immediately reduce your strides per minute or adjust the
resistance to return your heart rate to your physician-
recommended target zone.
User's Reference Manual: Heart Rate Features
Table 1. Heart rate target zones and SmartRate LEDs
Heart Rate Zone
Percent LED Lit
Below 50 First
50 to 54 Second
55 to 59 Third
60 to 64 Fourth
65 to 69 Fifth
70 to 74 Sixth
75 to 79 Seventh
80 to 84 Eighth
85 to 87 Ninth
Above 87 Tenth
The SmartRate indicator lights do not blink when:
• You do not wear or improperly position the chest strap. Or, you fail
to grasp both touch-sensitive handlebar grips for five to ten
seconds.
• You do not enter your age when prompted after you select a
program.
For example, pressing QUICKSTART at the Precor banner causes
the Manual Program to begin. Your age has not been entered and
is considered a null value. An LED does not blink in the SmartRate
display because the appropriate calculations have not been made.
Note: To remedy this situation after pressing QUICKSTART, press
MANUAL and then OK. Follow the prompts to enter your weight
and age.
LED Blinking Zone Label
Orange WARMUP
Orange WARMUP
Green FAT BURN
Green FAT BURN
Green FAT BURN
Green CARDIO
Green CARDIO
Green CARDIO
Orange PEAK
Orange HIGH
6