Turning On The Monitor - HP OMEN W9S97AA User Manual

Turning on the monitor

1. Press the power button on the source device to turn it on.
2. Press the power button on the rear of the monitor to turn it on.
CAUTION: Burn-in image damage may occur on monitors that display the same static image on screen for a
prolonged period of time.* To avoid burn-in image damage on the monitor screen, you should always activate
a screen saver application or turn off the monitor when it is not in use for a prolonged period of time. Image
retention is a condition that may occur on all LCD screens. Monitors with a "burned-in image" are not covered
under the HP warranty.
* A prolonged period of time is 12 consecutive hours of non-use.
NOTE: If pressing the power button has no effect, the Power Button Lockout feature may be enabled. To
disable this feature, press and hold the monitor power button for 10 seconds.
NOTE: You can disable the power LED in the OSD menu. Press the
and then select Power Control > Power LED > Off.
When the monitor is powered on, a Monitor Status message is displayed for five seconds. The message shows
which input is the current active signal, the status of the auto-switch source setting (On or Off; factory default
is On), the current preset display resolution, and the recommended preset display resolution.
The monitor automatically scans the signal inputs for an active input and uses that input for the display.
Menu button on the rear of the monitor,
Setting up the monitor 9