Advertisement
2
5
8
3
6
3.2
Setting the lawn mower up
1. Open the tapes and lift the upper part of the carton (Fig. 2).
2. Take out the components and put them down (Fig. 2).
3. Check completeness of contents.
Dispose packaging according to the local regulations.
3.3
Mounting the wheels
Note: First mount the wheel bearing with the "Smart-
Wheel" scale on the left in the back.
1. Push the wheel bearing the "Smart-Wheel" scale on the left-
4
hand side in the back onto the axle until engaged (Fig. 3).
2. Mount the other wheels.
Wheels must engage on the axles.
3.4
Mounting the handlebar
The cable must not be bent, pinched or damaged.
1. Unscrew the tommy nuts on the sides of the mower rear and
pull up the lower part of the handlebar until the locks engage
into the groove on the housing (Fig. 4 + 5).
7
2. Fasten the tommy nuts fingertight.
3. Add the upper part of the handlebar and put the screws from
the outside inwards into the bore holes (Fig. 6).
4. Fasten the upper part of the handlebar by screwing down the
butterfly nut fingertight.
5. Adjust the height of the handlebar with the tommy nuts on the
mower housing - asdjusting range approx. 10 cm (Fig.7).
© by The Toro Company
Advertisement
