Advertisement
13
16
10
14
3.8
Connecting the lawn mower
Important:
Use only approved outdoor extension cables with a
metallic section of at least 1.5 mm².
•
Check the cable for defects.
Never use a damaged cable.
•
Keep the cable off the cutter when mowing.
•
Do not let the cable chafe on edges and pointed or sharp
objects.
Do not pinch the cable.
1. Fasten the connecting cable leading to the motor to the
handlebar by means of the holding straps.
2. Connect the cable to the plug-in socket on the handlebar
15
(Fig.13).
3. Secure the cable with the strain relief (Fig. 14 + 15).
It is imperative to use the strain relief.
Make sure that the cable section between the plug-in socket
and the strain relief is of sufficient length so that the strain
relief may slight over the whole width of the handlebar (Fig.16)
4. Connect extension cord to mains
Notice: For mowing, do not use more cable length than necessa-
ry, never more than 50 meters in total. Longer cables will lead to
lack of power and raise the risk of overheating the electric motor
While using a cable drum, unroll cable totally, otherwise cable
could heat up more than allowed.
While leaving the mower, always pull
plug from mains. Never pull at the cable!.
© by The Toro Company
Advertisement
