Ethernet Wan Connections - D-Link DSL-2640U User Manual

DSL-2640U Wireless ADSL2+ Router with Ethernet WAN Support
User Manual
14. Go to the Advanced / Interface grouping page.
15. Create a group containing the WAN connection of the Bridge type and the LAN 2 port.
16. Create another group containing the WAN connection of the Dynamic IP type, the LAN 3
port, and the wireless interface.
17. Save the settings and wait until the router is rebooted.

Ethernet WAN Connections

In some cases, it is necessary to assign two WAN connections to one physical interface.
For example, the ISP provides the IPTV service via the VLAN with the tag (VLAN ID) 10 and
access to the Internet via the VLAN with the tag (VLAN ID) 20. Your private Ethernet line is
connected to the LAN 3 port of the router. You need to configure a WAN connection of the Bridge
type for the set-top-box connected to the LAN 2 port of the router and a WAN connection of
Dynamic IP type for the computer connected to the LAN 4 port of the router and the laptop
connected to the wireless interface of the router.
To configure the router, follow the steps below:
1. Go to the Advanced / EtherWAN page.
2. Place the mouse pointer on the LAN3 port and
3. Click the Apply button.
4. Go to the Net / WAN page and click the Add button.
5. Select the Bridge value from the Connection Type drop-down list.
6. Select the LAN3 value from the Interface drop-down list.
7. In the VLAN section, select the Use VLAN checkbox.
8. In the VLAN ID field, enter 10.
9. Click the Apply button.
10. Click the Add button again.
11. Select the Dynamic IP value from the Connection Type drop-down list.
12. Select the LAN3 value from the Interface drop-down list.
13. In the VLAN section, select the Use VLAN checkbox.
14. In the VLAN ID field, enter 20.
15. Click the Apply button.
Figure 106. Groups of ports for the created WAN connections.
Page 143 of 146
left-click it.
Operation Guidelines